Tower crane and workshop elevator in Qazvin

Sometimes a tower crane is used for assembly and disassembly of a workshop elevator. Of course, the tower crane can be used to assemble the workshop elevator if it is near the structure. The work process is that you first set up the stabilization base, which is one of the main components of the workshop elevator, then the next components of the workshop elevator are assembled using a tower crane. The advantage of this work is that the speed of installation and assembly of the workshop elevator increases. Using the workshop elevator self assembler is also one of the good tools for workshop elevator assembly. It happens in a situation where there is no tower crane, in this case the stabilization base must be set up first and then the assembly of the next parts such as the cabin and after that the assembly work is done by connecting the power and auxiliary winch to the self-assembling power device. takes Of course, assembling with this method is not as fast as assembling with a tower crane.

Dismantling a workshop elevator is a process in which the installed elevator is separated into its components and separated from the project site. This process includes the following steps: Dismantling planning: detailed planning to carry out dismantling operations with minimal impact on other project activities. Securing equipment: disconnecting electrical systems and securing all equipment to prevent accidents. Separation of components: The parts and components of the elevator are separated in the order of the photo of the assembly steps. Transportation of parts: Separated parts are transported to the warehouse or destination. Cleaning and inspection of the site: The installation site of the elevator is cleaned after disassembly and final inspections are carried out to ensure the absence of any remaining parts or damage.

The base to keep the workshop elevator stable Elevation sections of the workshop elevator Workshop elevator cabin Workshop elevator gearbox motor Workshop elevator parachute system Workshop elevator electrical panel

Foundation to keep the workshop elevator stable The location of the workshop elevator How to use a workshop elevator Before making the foundation, a smooth surface should be created and the thickness of the foundation should be 20 cm. Installation of height sections in the stabilization base The workshop elevator should be controlled by using a plumb line or a level. Installation of engines and gearboxes Installation of cable clamps on the sockets Installing the electrical panel and starting the elevator Install the belt to the height that is required Installing a mechanical stopper in the highest section to prevent falling Putting a spring under the cabins and closing the handrail above the cabin At the end of the work, all the screws should be greased and the cable clamps should be mounted, the restraining belts should be checked and the parachute test should be performed.

The height of the workshop elevator It is very important to align the workshop elevator with the structure Installing a tower crane near the structure and using the workshop elevator self-assembly method each has its own price. As you know, using a tower crane in the installation and assembly of a workshop elevator makes the work much easier, but this is despite the fact that the tower crane is already in that place and in It must be installed near the workshop elevator, otherwise the cost of assembly and disassembly of the workshop elevator will increase.

Safety: The correct and safe installation of a workshop elevator is very important to minimize possible risks. Efficiency: accurate and principled installation causes optimal elevator performance and reduces breakdowns and unwanted stops. Saving time: the fast and basic assembly and disassembly process by the expert team reduces project shutdown time and increases productivity.